13 1
If the c ause of the interruption to the p ow er
sup ply is not the discharged battery,
consult a workshop. We recommend your
Vauxhall Authorised Repairer. If the vehicle
has to be removed from m oving traffic,
release clutch as follows:
1. Ap ply hand brake and switch off
ig ni ti o n .
2. Open bonnet and engage support.
3. Clean Easytronic around the cap (see
figure) so that no dirt can get into the
opening when the cap is removed.
4. Rotate cap to slacken and remove by
lifting upwards – see figure.
5. Turn the a djusting screw clockwise using
a flat-head screwdriver (vehicle tools 3 –
see page 184) until clear resistance can
be felt. The clutch has now been
disengaged.
Do not turn beyond the resistance, since
this can damag e the Easytronic.
6. Fit cleaned cap again. The cap must be
in full conta ct with the housing.
Towing the vehicle and starting the eng ine
is not permitted when the clutch has been
released in this way, although the vehicle
can b e m oved a short distance.
Consult a workshop immediately. We
recommend your Vauxhall Authorised
Repairer.