53
Remote co ntr ol batt ery re plac em ent
Replace the battery as soon as the range
of the radio remote control begins to
shrink.
Separate the key part from the radio
remote control using a screwdriver as
illustrated.
The transponder for the immobiliser is in
the front of the key. Make sure that it is not
dam aged or detached.
Position screwdriver and open remote
control by making a gentle rotary
movement – see figure above.
Open the remote control. Prise out battery
with screwdriver. Replace b attery (b attery
type – see page 253), ensuring that it is
inserted correctly. Close the remote control
and audibly engage. Insert the remote
control in the key part and engage.
Battery replacement m ust be performed
within 3 minutes. Otherwise the remote
control will have to be resynchronised – see
ne xt co lu mn .
Make sure that you dispose of old batteries
in accordance with environmental
protection regulations.
Radio remote control synchronisation
If functionality is lost, synchronise the radio
remote control:
1. Switch on ignition; system will then
remain in synchronizing mode for
30 seconds.
2. Briefly press button p or q on the radio
remote c ontrol unit with the unit inserted
in the ignition.
3. The central locking system locks and
unlocks to show that the remote control
ha s b ee n sy nch ronized.
To Next Page
Loading...
Need help?
General
