18 9
7. Screw in wheel bolts and tighten slig htly,
inserting the wheel bolt wrench 3 as far
as possible.
8. Lower vehicle.
9. Tighten wheel bolts crossw ise, putting on
wheel bolt wrench 3 as far as possible.
10.Before refitting the wheel trim, clean the
wheel around the retaining clips. Valve
symbol 3 on back of wheel trim must
point towards valve on wheel.
Align and engage hub cap or wheel
trim 3 and wheel bolt c aps 3.
Alloy wheels 3 : Put hub cap on and
engage, inserting pin on rear of hub
ca p into relevant hole in wheel.
Alloy wheels with anti-theft lock 3: Put
hub ca p on. Insert and tighten anti-
theft lock 3.
11. Close the jacking point flap on the
underside of the vehicle 3. Stow the
repla ced wheel – see page 182. Put
away the tools and warning triangle –
see pages 180, 184.
12. Check the pressure of the newly fitted
wheel. Adjust as necessary.
13. Have the tightening torque of the wheel
bolts on the new whee l checke d on the
vehicle using a torque wrench as soon
as possible and, if necessary, corrected.
Tightening torque – see page 249.
14. Replace the faulty tyre on the wheel
that was rem oved.
15. Replace the temporary spare wheel 3
with a full specification wheel without
delay.
To Next Page
Loading...
