Note:
Please DO NOT pause update and make sure the connection between host and device
is reliable during firmware update. If the firmware is damaged, please reset and
update again.
No matter which method is used to update the firmware, you must ensure that the
firmware version attached to the host is higher than the terminal firmware version
before to update.
Please keep the firmware up to date and avoid upgrading across multiple versions.
The first and third upgrade methods will upgrade to the latest firmware in the LAN by
default, and the second upgrade method will upgrade to the latest firmware included
in the selected host.
4.7 Reset
Reset Configuration
- press F2 key on device boot.
This is to restore all custom configurations to factory default. This is often used for
restoring desktop resolution which is out of range of the monitor to 1027x768. If the
Setting Lock is enabled, you are required to enter password.
To Next Page
Loading...