Configuring the Wave ISM using the Installation Wizard 6-5
Chapter 6: Using the Wave Installation Wizard
Wave Server Installation Guide
• TDM Trunks—Assign analog and digital trunks to trunk groups and set
configuration options to match the settings your trunk service provider has
provisioned on your trunks. For more about setting up analog and digital
trunks, see Chapter 5 in the Wave Global Administrator Guide.
•
SIP Trunks—Set up Signaling Control Points and other IP telephony settings.
Note that the Installation Wizard checks for SIP Trunk licenses before
launching this applet—if you have not yet added any to your system via the
Licenses option, the SIP Trunks option will not be available. For more about
setting up SIP trunks, see Chapter 6, “IP Telephony Configuration” in the
Wave Global Administrator Guide.
•
Outbound Routing—Configure outbound routing rules and dialing permissions for
users. For more about configuring outbound routing, see Chapter 9 in the Wave
Global Administrator Guide.
•
Resource Management—Allocate DSP resources on your Wave ISM system.
Launches the Resource Management Advisor, which asks you a series of questions,
for example how many phones will be connected, how many simultaneous calls
need to be supported, and so forth. Based on your answers and the cards, modules,
and Wave licenses installed on your Wave Server, the Resource Manager Advisor
then lists the recommended resources that need to be allocated to support the
specified phone, trunk, conference, and call recording requirements. For more about
the Resource Management Advisor, see “Managing Wave system resources” in
Chapter 23 in the Wave Global Administrator Guide.
•
Password—Allows you to change the default password for the factory-supplied
Wave user. Changing the default password is highly recommended for security
reasons.
3. Click
Done to return to the Installation Wizard screen.
4. Continue selecting tasks in the left pane. When you are done, click
Finish, and then
confirm that you are done. Since you cannot re-run the Installation Wizard be sure that
you have made all of your changes before exiting.
Note: You can run the various applets directly from the Global Administrator
Management Console at a later time to make further changes. For more information about
all of the configuration and customization options available in Wave, see the Wave Global
Administrator Guide.
To Next Page
Loading...
