Vertical WAVE IP 2500 - Workstation Setup Command Parameters

Workstation Setup command parameters D-3
Appendix D: Performing Unattended Workstation Installations
Wave Server Installation Guide
The following sample command installs all of the workstation applications in the default
location:
setup.exe /s /v"/qn CUSTOM_INSTALL=1 INSTALLLEVEL=200
ADDLOCAL=ALL"
The following sample command does the following:
• Installs the single-line TAPI Service Provider in the default location.
• Installs the Contact Manager Assistant in the specified location.
• Configures the single-line TAPI Service Provider.
• Launches the Contact Manager Assistant when the installation completes, if a
restart is not required.
setup.exe /s /v"/qn CUSTOM_INSTALL=1 INSTALLLEVEL=200
ADDLOCAL=TSP,CMA TVSERVER=CompanyServer TVSTATION=1
TVUSER=Operator TVPASSWORD=0 TVTSPAPPHANGUP=1 TVTSPTRACE=1
TVCMAFOLDER=/"C:\Program Files\CMA/" TVLAUNCHCMA=1 /l*v
%TEMP%\wssetup.log"
When run on a Terminal Server PC, the following command installs all of the workstation
applications in the default location:
setup.exe /s /v"/qn CUSTOM_INSTALL=1 INSTALLLEVEL=200 ADDLOCAL=ALL
TERMINALSVRMODE=1"
Workstation Setup command parameters
The following parameters can be specified in any order. Separate parameters with spaces.
Name Value Description
CUSTOM_INSTALL Integer Installation type:
0 = (Default) Typical installation.
1 = Custom installation.
INSTALLLEVEL 200 Required whenever you use the ADDLOCAL parameter (not
required to REMOVE a workstation application.)
Release 4.0
June 20, 2013