Connecting a paging system 3-26
Chapter 3: Setting Up the Wave IP 500 Server
Wave Server Installation Guide
Connecting a paging system
A paging system allows Wave users to make public announcements over a loudspeaker.
The Wave Server is compatible with most standard paging systems that connect via a 3.5 mm
stereo plug. If a cable is not provided, you must purchase one separately.
Note: Although a stereo cable is required, only one channel is used for paging.
Caution: Always follow the instructions supplied by the manufacturer of your paging system
when installing and connecting the system to avoid possible injury to yourself or damage to the
equipment.
To connect a paging system:
1. Locate the audio output port (labeled Audio Out) on the front of the ISC2.
2. Connect the cable from your paging system to the port.
3. Enable paging in the General Settings applet of the Global Administrator Management
Console. See the Wave Global Administrator Guide for more information.
To Next Page
Loading...
