EasyManua.ls Logo

Vertical WAVE IP 2500 - Installing Workstation Applications on an Application Server; Installing Workstation Applications on a Windows 2003 Server

Vertical WAVE IP 2500
236 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installing workstation applications on an application server A-2
Appendix A: Using Wave Workstation Applications with Microsoft Terminal Services or Citrix MetaFrame
Wave Server Installation Guide
Installing workstation applications on an application server
Bear the following considerations in mind when you set up an application server for Wave:
The application server cannot be the same PC as your Wave Server.
Applications should not be installed in the same partition as the Windows operating
system. In most cases, Windows will be installed on your C drive and applications will be
installed on a D drive. The D drive can either be a separate hard disk or another partition
on the same disk as the C drive.
Always use Add/Remove Programs (located on the Windows Control Panel) to install
programs. This ensures that the programs are set up properly for multi session use.
Important: The server must be in remote administration mode to remotely install any
Wave workstation applications. See “Installing workstation applications on a Windows
2003 server” on page A-2.
Installing workstation applications on a Windows 2003 server
To install the Wave workstation applications on a Microsoft Windows 2003 Terminal Server,
see the documentation that came with Terminal Services.
Release 4.0
June 20, 2013

Table of Contents

Other manuals for Vertical WAVE IP 2500