About the Wave IP 500 Server 3-3
Chapter 3: Setting Up the Wave IP 500 Server
Wave Server Installation Guide
Wave IP 500 Server components
The Wave IP 500 Server consists of the following:
• 19-inch rack-mountable chassis that includes room for expansion.
• VAM (1GHz Celeron, 1GB memory)
• Power supply
• Integrated Services Card 2 (ISC2), an embedded processor that provides primary system
control including voice processing and packet switching elements.
• One solid-state drive (SSD) and one large-storage hard disk drive (HDD).
Important: This dual-drive configuration is provided on all new Wave Servers, and is
the preferred configuration for all Wave Servers going forward. Contact your Wave
provider for information about available upgrade paths for existing Wave Servers.
To Next Page
Loading...
