Connecting the Wave IP 2500 Server to power and powering on 4-12
Chapter 4: Setting Up the Wave IP 2500 Server
Wave Server Installation Guide
Connecting the Wave IP 2500 Server to power and powering on
Connect the Wave IP 2500 Server to a dedicated circuit using the supplied power cord. Do not
use any other power cord.
Note: There are 2 power cord models, one for use in the US and one for International (EU) use.
See Appendix D in the Wave Server Hardware Reference Guide for voltage and current
specifications.
To connect the Wave IP 2500 Server to power and power on:
1. Locate the power outlet and power toggle switch on the back of the Wave Server base
unit.
2. Set the base unit power supply rocker switch and any EXU power switch rocker switches
located on the back of the Wave Server base unit to the off position.
3. Connect the power cables from the base unit and any EXUs to dedicated circuits.
4. Set each EXU's rocker switch to the On position. (The EXU will not actually power on
until the base unit is powered on.)
5. Power on the base unit by toggling the rocker switch.
6. Observe the status LEDs on the front of the Wave Server base unit to ensure that the
system initialization completes successfully and that there are no component failures.
For complete details of the information provided by the status LEDs, see Appendix C,
“Integrated Services Card Status LEDs.”
To Next Page
Loading...