Mounting the Wave IP 2500 Server 4-6
Chapter 4: Setting Up the Wave IP 2500 Server
Wave Server Installation Guide
Media Resource Modules (MRMs)
Each Wave ISM system is pre-configured to support a specific number of users and concurrent
voice applications. To expand the system’s core telephony, voice processing, and VoIP
capabilities you can add a Media Resource Module. The MRM is a mezzanine-style daughter
board that is installed on the Integrated Services Card (ISC1).
You can install one MRM on the Wave IP 2500 Server. There are 3 available MRM models
(MRMA, MRMB, and MRMC) that provide up to 128, 256, or 384 additional voice processing
channels.
Note: At least one MRM is required if you plan to use Quality of Service (QoS) settings with
IP resources for VoIP calls. Contact your Wave provider for more information.
For installation instructions, see page 4-17.
Mounting the Wave IP 2500 Server
The Wave IP 2500 Server can be rack mounted, wall mounted, or table mounted. See
“Environmental requirements” on page 2-4 for specific requirements on how to prepare the site
the where the Wave Server will reside.
Caution: Due to the weight of the Wave Server, mount it with assistance whenever possible.
Review “Proper lifting” on page 2-7 before rack mounting.
Important: Note the following:
• Do not place anything on or against the base unit that prevents proper ventilation. Be sure
to allow a minimum cooling clearance of 4 inches on all sides of the Wave Server.
• To prevent the fans from pulling dust into the base unit, mount the Wave Server at least 2
feet (0.5 meters) above the floor. Do not operate the Wave Server at floor level.
To Next Page
Loading...
