Verifying installed hardware components 7-30
Chapter 7: Initial Configuration
Wave Server Installation Guide
3. If a module or card is not displayed as expected in Chassis View, check the physical
status LEDs on the Wave Server to make sure they are green (on and operational).
If the physical LEDs are off (nonoperational):
a. Shut down and power off the Wave Server according to the instructions on
page 7-13.
b. Reseat the component in question. For more information, see page 3-17 or
page 4-20 (depending on your Wave Server model).
c. Restart the Wave Server according to the instructions on page 7-13, and run
the Chassis View applet again.
Chassis View should now show the component in question as present and functioning
normally. If the component is still not displayed in Chassis View, contact your Vertical
support representative.
4. Click
Done to return to the Global Administrator Management Console.
To Next Page
Loading...
