Vertical WAVE IP 2500 - Page 9

TOC-5
Contents
Wave Server Installation Guide
Connecting the T1 module with serial interface - - - - - - - - - - 4-25
Connecting the T1 module (without serial interface) - - - - - - - 4-26
Connecting the E1 EuroISDN module with serial interface - - 4-26
Connecting the Quad BRI module - - - - - - - - - - - - - - - - - - - 4-27
Connecting the analog station card - - - - - - - - - - - - - - - - - - - 4-28
Connecting the digital station card - - - - - - - - - - - - - - - - - - - 4-28
Connecting a music-on-hold (MOH) system - - - - - - - - - - - - 4-29
Connecting a paging system - - - - - - - - - - - - - - - - - - - - - - - 4-29
Connecting a DSS Console - - - - - - - - - - - - - - - - - - - - - - - - 4-30
Chapter 5 Connecting to the Wave ISM from the administrator PC
Obtaining all required HotFixes - - - - - - - - - - - - - - - - - - - - - - 5-1
Administrator PC requirements - - - - - - - - - - - - - - - - - - - - - - 5-2
Configuring the administrator PC - - - - - - - - - - - - - - - - - - - - - 5-3
Connecting to the Wave ISM - - - - - - - - - - - - - - - - - - - - - - - - 5-5
Connecting to the Wave Server via your network - - - - - - - - - - - - - - - - - 5-6
Connecting to the Wave ISM via a modem - - - - - - - - - - - - - - - - - - - - 5-10
Chapter 6 Using the Wave Installation Wizard
About the Wave Installation Wizard - - - - - - - - - - - - - - - - - - - 6-1
Running the Wave Installation Wizard - - - - - - - - - - - - - - - - - 6-2
Configuring the Wave ISM using the Installation Wizard - - - - - 6-2
Release 4.0
June 20, 2013