Vertiv Liebert EXM2 - Page 6

8.2.3 External Protective Device 141
8.2.4 Power Cable 141
8.2.5 Parallel Cable 142
8.2.6 Remote EPO 143
8.3 Operation Procedures for Parallel System 144
8.3.1 Startup Procedures in Normal Mode 144
8.3.2 Maintenance Bypass Procedures 145
8.3.3 Procedures for Isolating One UPS Module from Parallel System 146
8.3.4 Procedures for Inserting One Isolated UPS Module in Parallel System 147
8.3.5 Procedures for Completely Powering Down UPS 147
8.3.6 Procedures for Complete UPS Shutdown while Maintaining Power to Load 147
8.4 LBS System 148
8.4.1 Cabinet Installation 148
8.4.2 External Protective Device 149
8.4.3 Power Cable 149
8.4.4 LBS Cable 150
9 O ptions 153
9.1 Option List 153
9.2 Option Introduction 154
9.2.1 Optional Side Cabinet 154
9.2.2 Bypass Short-circuit Withstand Option 157
9.2.3 Battery Temperature Sensor 158
9.2.4 Battery Ground Fault Kit 158
9.2.5 Seismic Anchor Kit 159
9.2.6 IS-UNITY-DP Card 162
9.2.7 IS-UNITY-LIFE Card (Available in Specific Regions only) 162
9.2.8 SIC Card (Available in Specific Regions only) 163
9.2.9 UF-RS485 Card 164
9.2.10 IS-Relay Card 165
9.2.11 BCB Box 166
9.2.12 Parallel Cable 166
9.2.13 LBS Cable 166
9.2.14 Back-feed Contactor Option 166
9.2.15 Top Fan Kit 167
9.2.16 Input/output Switch Kit 168
9.2.17 IP21 Option 169
9.2.18 IP31 Option 170
9.2.19 Transformer 171
9.2.20 C2 Electromagnetic Shielding Option 172
9.2.21 CPSS Model Option 172
9.2.22 LBS Adapter 173
iv
Vertiv™ Liebert® EXM2 UPS User Manual