Vertiv SmartCabinet - Page 24

Vertiv | SmartCabinet | User Manual 15
System Installation
Figure 2-4 Fittings
The tting nuts and their usage are shown in the following Table 2-2.
Table 2-2
Fitting Utility Usage
Floating Nut Used together with the M6 screw to install the parts in the
cabinet
M5 Countersunk head screw Used to install the cabinet connector
M6 Panel screw Used to install the power distribution unit, monitoring
system, & User equipment
M6 Pan head screw Used to connect and x the frame
M6 Flange nut Used together with the M6 Pan head screw to install the L
Fastener
Adhesive Tape Used to seal the gap between the connected frames
Cable tie Fixture kit Used to x & bind the cables
Accessories
The following table (Table 2-3) displays the various accessories used in the Installation processes for the
600/800mm standard unit and the 600mm unit with the integrated condenser respectively:
Table 2-3
For the 600/800mm Standard Unit
Sr. No. Product Name Quantity Note
1 Cable Tie 30
Accessory Box 1
2 Cable Tie Fixture 10
3 OT Terminal 4
4 Floating Nuts, M6
Panel screw
30 (set)
5 Floating Nut Hook 1
6 MSC Intelligent
Monitoring Card
1 (set)
7 Hairbrush 1