Victory 2009 VISION User Manual

109
OPERATION
Operation
Engine Break-In Period (Cont.)
0-90 miles (0-145 Kilometers)
Do not operate the motorcycle for extended periods of time at throttle positions above 1/3
throttle. Vary the engine speed of the motorcycle. Do not operate the motorcycle for
extended periods of time at any one set throttle position.
91-300 miles (146-483 Kilometers)
Do not operate the motorcycle for extended periods of time at throttle positions above 1/2
throttle. Vary the engine speed of the motorcycle. Do not operate the motorcycle for
extended periods of time at any one set throttle position.
301-500 miles (484-800 Kilometers)
Do not operate the motorcycle for extended periods of time at throttle positions above 3/4
throttle.
After 500 miles (After 800 Kilometers)
Perform initial maintenance as described in the Maintenance section of this Rider’s
Manual. This maintenance is one of the most important services your motorcycle requires
and should be performed by an authorized VICTORY dealer. Initial maintenance service
must include inspection / adjustments, tightening of fasteners, and engine oil and filter
change. Performing this maintenance at the required mileage point helps ensure peak
engine performance, minimal exhaust emissions, and maximum service life of the engine.
visionownersmanual.book Page 109 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches