Victory 2009 VISION User Manual

110
OPERATION
Operation
Fueling Precautions
Fuel the motorcycle with the sidestand down and on level ground. Use only the
recommended fuel (see Fuel Specifications on page 247). Fill the fuel tank to a level just
below the bottom of the fuel filler neck. Fuel door operation is on page 77.
WARNING
• Do not allow gasoline to come into contact with a hot engine or exhaust system. This
could cause a fire. Immediately wipe, or rinse with water, gasoline spilled on any part of
the motorcycle or the surrounding area.
• Do not fill the fuel tank above the fuel filler insert. Overfilling the fuel tank may cause fuel
to overflow when it expands.
• Fuel may leak from an improperly seated fuel cap. Be sure the fuel cap properly seated
before starting the engine.
CAUTION
Fuel can damage painted surfaces and plastic parts. Wipe spilled fuel immediately from the
motorcycle using a clean, dry, soft cloth.
visionownersmanual.book Page 110 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches