Victory 2009 VISION User Manual

111
OPERATION
Operation
Priming the Fuel System
If the motorcycle has run completely out of fuel, prime
the system before starting the engine.
1. Fill the fuel tank.
2. Turn the ignition key ON.
3. Turn the engine stop switch to the RUN position (the
fuel pump will run momentarily).
4. Wait for the pump to stop running (about 3 seconds).
5. Turn the engine stop switch to STOP and wait 10
seconds.
6. Repeat steps 3-5 four or five times to thoroughly
prime the fuel system.
7. Turn ignition key OFF.
8. Start the engine following normal procedures.
visionownersmanual.book Page 111 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches