Victory 2009 VISION User Manual

141
MAINTENANCE
Maintenance
Engine Oil & Filter Change (Cont.)
6. Clean the drain plug sealing surface on the crankcase. Remove the old seal washer
from the plug and install a new one.
7. Install the drain plug and tighten to the proper torque. DO NOT overtighten.
DRAIN PLUG TORQUE: 15 lb-ft. (20 Nm).
8. Clean the oil filter mounting threads and gasket sealing surface on the crankcase.
9. Make sure the new oil filter gasket is properly seated in the new oil filter, and apply a
thin film of clean engine oil to the gasket. Screw the new filter on until the gasket
contacts the filter mounting plate. Tighten the filter by hand an additional 3/4 turn.
10. Fill crankcase through the oil fill cap with approximately 4.5 quarts (4.25 liters) of oil.
Use only VICTORY brand Semi-Synthetic 20W-40 Motor Oil or equivalent oil for use
with wet clutches such as JASO MA rating.
CAUTION
Do not add chemical additives to the engine oil. Some automotive engine oils contain
additives that could damage or reduce the service life of the wet clutch in your motorcycle.
visionownersmanual.book Page 141 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches