Victory 2009 VISION User Manual

142
MAINTENANCE
Maintenance
Engine Oil & Filter Change (Cont.)
11. Reinstall the oil fill cap. Start and run the engine
until it reaches normal operating temperature.
NOTE:
After an oil change, the low oil pressure indicator
remains illuminated longer than usual before
going out. Do not rev the engine while the low oil
pressure indicator is illuminated.
12. Stop the engine and make sure there are no
leaks around the drain plug and oil filter.
13. Check the oil level and adjust if needed.
NOTICE:
Recycle used oil and filter in accordance with
local regulations.
ENGINE OIL CAPACITY AT
CHANGE (WITH FILTER)
Approx. 4.5 qt.
(4.25 liter)
ENGINE OIL CAPACITY AT
CHANGE (WITHOUT FILTER)
Approx. 4.0 qt.
(3.8 liter)
1
Approx. 1 qt. (.9 l)
visionownersmanual.book Page 142 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches