Victory 2009 VISION User Manual

52
INSTRUMENTS, FEATURES, & CONTROLS
Controls
Clock
1. Turn the key to ON or ACC to view the clock. To change the
setting, use the MODE button to toggle to the odometer.
2. Press and hold the MODE button until the hour segment
flashes, then release the button. Tap the MODE button to
advance to the desired setting.
NOTE:
If LOW FUEL is flashing, the display will not enter the CLOCK
SET mode.
3. Repeat step 2 to set the 10-minute and 1-minute segments, then press and hold the
MODE button to save the settings and exit the CLOCK SET mode.
4. Turn the key off. The clock is set until the
battery is disconnected or discharged.
Error Screen
If “Err” appears in the clock area, record the three
code numbers displayed on the screen. See an
authorized VICTORY dealer for code details. See
“Check Engine” indicator information on page 59.
Clock
Avg
C
F
8
881
88
:
88
8.88
:
88
:
8
Speed Range Inst Time
TRIP 1
TRIP 2
km / h
miles / gah
Error Code
Number (0-9)
“Err”
Suspect Parameter Number (SPN)
Failure Mode
Indicator (FMI)
visionownersmanual.book Page 52 Wednesday, February 13, 2008 4:31 PM

Victory 2009 VISION Specifications

General

Year	2009
Manufacturer	Victory
Model	VISION
Category	Touring
Compression Ratio	9.4:1
Cooling System	Air / oil
Transmission	6-speed
Final Drive	Belt
Front Tire	130/70-R18
Rear Tire	180/60-R16
Engine Type	V-twin, four-stroke
Displacement	1731 cc
Bore x Stroke	101 x 108 mm
Fuel System	Electronic Fuel Injection
Front Suspension	Telescopic fork
Rear Suspension	Single
Front Brakes	Dual 300mm discs, 4-piston calipers
Rear Brakes	Single 300mm disc 2 piston caliper
Seat Height	26.5 inches
Fuel Capacity	22.7 liters / 6.0 US gallons
Wheelbase	65.7 inches