Vigilant MX1 - Recalling Zone and Point Status

Document: LT0344 Vigilant MX1 Operator Manual
Issue 2.4 8 August 2017 Page 5-1
This chapter describes using the front panel to view the status of zones
and points.
The various states that zones and points can have are described on
pages 1-12 and 1-15 respectively.
Note; some points may be recallable and appear to be in various
“normal” states, but cannot have commands performed upon them. This
may be due to the configuration settings used in a particular MX1
installation, or that the points are for display-only purposes.
Equipment Points are listed on page 11-2.
Refer to the page number listed in this table for information on a specific
topic.
Topic
See Page
Recall Menu Options
5-2
Recalling Off-Normal Points and Zones
5-3
Using the Zone Button to Recall Points and Zones
5-8
Chapter 5
Recalling Zone and Point Status
Introduction
In this Chapter