Vigilant MX1 - Zone and Point Functions

Document: LT0344 Vigilant MX1 Operator Manual
Issue 2.4 8 August 2017 Page 6-1
This Chapter describes use of the front panel to change the status of
zones and points.
Except where noted, all these commands require operator Access Level
2. See page 1-11 for more information about Access Levels.
Equipment points are described on page 11-2.
Refer to the page number listed in this table for information on a specific
topic.
Topic
See Page
Displaying Zone or Point Command Menu
6-2
Resetting Zones or Points
6-2
Disabling and Enabling Points or Zones
6-6
Testing Zones
6-12
Testing Points
6-16
Viewing Point Values and Settings
6-18
Chapter 6
Zone and Point Functions
Introduction
In this Chapter