Vigilant MX1 - Other Service Functions

Document: LT0344 Vigilant MX1 Operator Manual
Issue 2.4 8 August 2017 Page 8-1
This chapter describes other service functions that are available from the
MX1 front panel.
Some of these commands require operator Access Level 3. See Chapter
7 for how to log on to operator Access Level 3.
Refer to the page number listed in this table for information on a specific
topic.
Topic
See Page
Front Panel Display Test
8-1
Setting System Time and Date
8-2
Power Supply Status and Battery Testing
8-3
MX Loop Status
8-5
System Memory Status
8-7
Test System
8-10
Test Alarm Devices
8-11
Replacing an MX Device
8-12
Buzzer Disable and Mute
8-14
Commissioning Mode (Access Level 3)
8-16
Resetting the System (Access Level 3)
8-17
This function requires Access Level 2.
The LCD and indicator lights on the front panel of the MX1 can be quickly
checked for correct operation by using the display test.
If the MX1 display is not showing one of the base displays, i.e., Normal,
Off-Normal, Fault or the Alarm list, press CANCEL until the base display
is reached.
Press MENU to see a set of options.
Chapter 8
Other Service Functions
Introduction
In this Chapter
Front Panel Display Test
Testing the
Front Panel
Display