Visionix vx65 - Page 53

Using the VX65
VX65 User Guide
53 / 86
Control the cross cylinder (XCyl)
No
Description
Notes
1
Position 1 of XCyl
If XCyl is currently used: call the “1” position of XCyl.
If XCyl is not used: call the XCyl on right eye and call the
“1” position.
2
Position 2 of XCyl
If XCyl is currently used: call the “2” position of XCyl.
If XCyl is not used: call the XCyl on left eye and call the
“2” position.
Remarks:
If DUAL XCyl is currently used (available in Automatic mode only): there is no action clicking
on “1” or “2”.
When XCyl is automatically called by the clicking on “1” or “2”, the value of XCyl (±0.25 or
±0.50) is the one defined for XCyl in Manual mode.