The functionalities of selection and modifications are the same than in automatic mode of
examination interface.
Remark: there is no change in the phoropter head during the modification, it fills only OBJ or
LM data.
How do I start the exam from OBJ or LM data?
➢ Activate the use of VXBox.
➢ Activate the use of OBJ and/or LM data.
➢ In the settings, select with which data you want to start with (OBJ, LM or none).
When data from OBJ/LM are loaded, it will be automatically copied in SUBJ1 according to
this setting. If none is selected, there is no automatic copy in SUBJ1.
Remark:
It is also possible to manually copy/paste data from Exam file interface.
See also
How do I copy/paste data? page 75
To Next Page
Loading...
