Visionix vx65 - Page 87

To Previous Page

LUNEAU TECHNOLOGY SAS

2 Rue Roger Bonnet, 27340 Pont-de-l’Arche - France

Tél. + 33 232 989 132 - Fax + 33 235 020 294

contact@visionix.com

www.visionix.com

This document is not contractual. Features and specifications

are subject to change without prior notice.

Main Page

Table of Contents2
Introduction5
Indications for Use5
Warning5
Safety6
Electricity6
Transport, Storage, and Handling7
Precautions During Use7
Symbols8
Electromagnetic Emissions8
Electromagnetic Immunity9
Equipment and Installation11
List of Equipment Supplied12
Description of the Device13
Phoropter Head13
Tablet15
Keyboard (Optional)16
Installation Procedures17
Site Requirements17
Unpacking the Unit17
Setting up the System18
Connecting the Phoropter to the Tablet21
Connecting the Phoropter to the Chart Display22
Connecting the Tablet to the Keyboard (Optional)24
Using the VX6525
Main Menu26
Examination Interface: Manual & Automatic Modes27
Examination Interface: Manual Mode28
Main Buttons & Refraction Values28
Interactions in Manual Mode30
Accessories Abbreviations31
Retinoscopy Activated32
Examination Interface: Automatic Mode33
Heading Area33
Refraction Area34
Accessories36
Interface When Cross Cylinder Is Used37
Examination Interface: Chart Display Control39
Examination Interface: Program Mode41
Input Data Window42
Exam File Interface45
Overview of the Exam File Interface45
Data-Set Types46
Use of Keyboard (Optional)48
The Different Areas48
Use of Keyboard in Exam File Interface55
Configuring the VX6556
General Configuration57
Refraction Configuration58
Program Configuration60
Connection Configuration62
Export Configuration63
Chart Display Configuration64
Maintenance65
How Do I66
How Do I Prepare an Exam67
How to Turn on the System67
How Do I Receive Measurements from Other Devices67
How Do I Manually Insert or Modify Refractions from an OBJ or LM67
How Do I Start the Exam from OBJ or LM Data68
How Do I Use Manual Mode of Examination Interface69
How Do I Adjust the Pupillary Distance69
How Do I Change the Refraction Values69
How Do I Select the Correct Obturation '(Closed or Open)69
How Do I Switch between the Far and Near Vision Positions69
How Do I Use the Cross Cylinder70
How Do I Use the Prisms70
How Do I Use Automatic Mode of Examination Interface71
How Do I Adjust the Pupillary Distance71
How Do I Change the Refraction Values71
How Do I Select the Correct Obturation '(Closed or Open)71
How Do I Switch between the Far and Near Vision Positions72
How Do I Use the Cross Cylinder72
How Do I Change the Cross Cylinder Value72
How Do I Stop a Cross Cylinder Test73
How Do I Use the Equivalent Sphere Feature73
How Do I Use the Prisms73
How Do I Control the Chart Display74
How Do I Measure Visual Acuity74
How Do I Modify Optotype Masks74
How Do I Manipulate Data75
How Do I Display Other Refractions75
How Do I Copy/Paste Data75
How Do I Clear Data75
How Do I Load Data of the Previous Exam76
How Do I End an Exam77
How to Turn off the System77
What Should I Do if78
Troubleshooting79
Maintenance80
Instructions for Care81
Cleaning the Unit81
Appendices82

Visionix vx65 - Page 87

Table of Contents

Related product manuals