Visonic POWERMASTER 10 - Page 38

D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide 37
Step 6

Step 7

Step 8

Step 9

Step 10
Enter Location Menu [6] Select Location
(see list below)
[7] Enter Zone Type [8] Select Zone Type
(see list below)
[9]
➯

➯



Continue to
Step 11.
Step 11

Step 12

Step 13

Step 14

Step 15
Enter
Chime Menu
[11]
Select Chime option
[12]
Enter Partitions
∗
Menu
[13]
Select Partition
options
[14]
➯

➯


Continue
to Step
16.
Step 16

Step 17

Step 18
Enter Device
Settings Menu
[16] Configure Device
Parameters
[17] Continue
or End
➯

Refer to device
datasheet in the device
Installation Instructions
for specific
configuration
instructions.
See  [14].
To
continue
– See 
[5]
Location List
No.
Location
Name
No.
Location Name
No.
Location Name
No.
Location Name
01 Attic 09 Dining room 17 Hall 25 Utility room
02 Back door 10 Downstairs 18 Kitchen 26 Yard
03 Basement 11 Emergency 19 Laundry room 27 Custom 1
04 Bathroom 12 Fire 20 Living room 28 Custom 2
05 Bedroom 13 Front Door 21 Master bath 29 Custom 3
06 Child room 14 Garage 22 Master bedroom 30 Custom 4
07 Closet 15 Garage door 23 Office 31 Custom 5
08 Den 16 Guest room 24 Upstairs
Zone Type List
No. Zone Type Description
01 Exit / Entry 1
Used for Door/Window Contacts and Motion sensors protecting your entrance door
to the house. Provides you enough time to exit the premise after you arm the system
and to enter the premises and disarm the system before the alarm goes off. For
configuring the Exit and Entry 1 delays, see sections 3.5.1 & 3.5.2 - Installer menu
options 01 and 03. ( ∗ )
∗
Refers to PowerMaster-30 only
Z10:SET CHIME chime OFF

melody-chime
Z10:PARTITIONS Z01:P1

P2 P3
Z10:DEV SETTINGS
03.CONTROL PANEL
5. Interior
1:Exit/Entry1

Z10:ZONE TYPE
Kitchen
Front door

Z10:LOCATION