– Entering the "PGM Output" Menu
To Select an Option:
[1]
Enter the Installer Menu and select the option (see section 3.2).
[2]
Select the sub-menu option you need, for example: .
[3]
Select the parameter you wish to configure for example:
[4] To continue, go to the Section of the selected sub-menu option and look for the option you wish to
configure. After configuring the selected parameter the display returns to step 3.
[5] The "toggle" option setting is available only for "PGM: BY KEYFOB".
[6] Select "Turn on" to activate the PGM device, "Turn off" to stop the PGM device and "disable" to deactivate
the PGM device.
[7] The time selection will take effect when the "activate PULSE" is enabled.
[8] Select "start" / "stop" and enter the desired time.
To Change the Configuration of the Selected Option:
When entering the selected option, the display shows the default (or the previously selected) setting marked
with ().
If you wish to change the configuration, scroll the "Option settings" menu and select the setting you
wish and press to confirm. When done the display bring you back to Step 3.
05:OUTPUTS
PGM: BY ARM AWAY
PGM: BY ARM HOME
disable
To Next Page
Loading...
