Wacker Neuson G 240

wc_tx003619gb_FM10.fm
111
Mobile Generator
Operation (Deep Sea Controller)
9.10 Engine and Generator Monitoring
Description Engine and generator information is displayed on the LCD panel and scrolls
continuously while the generator is operating.
For more information on the Deep Sea controller, see chapter Working with the
Deep Sea Controller.
Volts “V”- Displays the AC output voltage being produced by
the generator.
Amps “A” - Displays the AC output amperage produced by the
generator. If the generator is operating at no-load, output
amperage will display a 0.
Hertz “Hz” - Displays output frequency. This gauge should
read approximately 60 Hz under a no-load condition. If the
frequency is too high, check the engine rpm
Displays the available voltage of the battery
Displays the percentage of fuel remaining in the fuel tank.
Displays the engine oil pressure (if equipped)
Displays the current temperature of the engine coolant
Generator Available
L-N
L-L
0 kW
480 V 59.9 Hz
--- pf
277 V
0 A
wc_gr009841
wc_gr009842
Engine Battery Voltage
Battery
Charge Alt
V
V
25.5
0.0
25.5
0.0
wc_gr009843
Engine Fuel Level
6666
%
wc_gr009844
Engine Oil Pressure
4.14
bar
60
psi
4.14
4.14
60
4.14
kPa
wc_gr009845
Engine Coolant Temp.
16
60
16
60
C
o
F
o