Wacker Neuson G 240

wc_tx003619gb_FM10.fm
99
Mobile Generator
Operation (Deep Sea Controller)
9.3 Selecting the Voltage
Background Selecting the voltage is a two-step process. First, select the voltage using the
voltage selector. Then, use the voltage adjustment rheostat to fine-tune the voltage
to your exact requirements.
Location The voltage selector (a) is located behind the access door in the upper half of the
control box.
Voltage
ranges
The chart below lists the ranges of voltages available in both of the selector
positions. The voltage is displayed on the LCD panel.
This procedure continues on the next page.
WARNING
Electric shock and arc flash hazard. High voltage is present at the voltage selector
while the engine is running.
► Do not open the access door while the engine is running.
► Do not change the position of the voltage selector while the engine is running.
wc_gr010389
a
Switch position
Range of Voltages Available
3Ø at lugs
(L–L–L)
1Ø at lugs
(L–N)
1Ø at lugs
(L-L)
1Ø at twist lock 1Ø at GFCI
L-N (120V) L-L (240V)
240 VAC 190–240 110–139 190–240 110–139 190–240 110–139
480 VAC 380–480 220–277 190–240 110–139 190–240 110–139