wc_tx003618gb_FM10.fm
55
Mobile Generator
Operation (Basler Controller)
7.2 Engine Start Switch
Description
The engine start switch (a) is a three-position switch: “REMOTE START”, “OFF”,
and “START/RUN”.
Function
AUS
APAGADO
ARRET
OFF
REMOTE START
FERNSTART
ARRANQUE REMOTO
DEMARRAGE A
DISTANCE
START / LAUFEN
ARRANQUE / MARCHA
DEMARRER / MARCHE
START / RUN
a
wc_gr011436
Position Function LCD Screen
REMOTE START This position is used when the generator is
being operated as a stand-by power supply, and
it is connected to a remote switch. The
generator is in stand-by mode and will not start
until the remote switch is activated (closed).
READY screen
START/RUN This is the normal start and run position. When
set to this position, power is supplied to the
genset controller which immediately launches
the start-up sequence.
As a precaution, be prepared for engine startup
anytime the engine start switch is in the
REMOTE START position.
Monitoring
screen
OFF Power to the genset controller is disconnected. Blank screen (off)
To Next Page
Loading...