Wacker Neuson G 240 - Maintenance Schedule

wc_tx003751gb_FM10.fm
187
Engine Maintenance: T4F Cummins QSB7-G9
The engine maintenance schedule(s) in this chapter are reproduced from the
engine owner’s manual. For additional information, see the engine owner’s
manual.
Maintenance Schedule
Perform maintenance at whichever interval occurs first. At each scheduled
maintenance interval, perform all previous maintenance checks that are due for
scheduled maintenance.
Maintenance Procedures at Daily Interval
• Air Intake Piping - Check
• Fan, Cooling - Inspect for Reuse
• Crankcase Breather Tube - Check
• Air Tanks and Reservoirs - Drain
• Coolant Level - Check
• Fuel-Water Separator - Drain
• Lubricating Oil Level - Check
• Aftertreatment Exhaust Piping - Check
• Dust Ejection Valve - Check
• Diesel Exhaust Fluid (DEF) Level - Check
Maintenance Procedures at 250 Hours or 3 Months
• Air Cleaner Restriction - Check
• Charge-Air Piping - Check
• Charge-Air Cooler - Check
• Radiator Hoses - Check
• Air Intake Piping - Check
• Radiator - Check
Maintenance Procedures at 500 Hours or 6 Months
• Fuel Filter (Spin-On Type) - Change
6
• Lubricating Oil and Filters - Change
1, 7
• Engine Coolant Antifreeze - Check
2
• Batteries - Check
4
• Battery Cables and Connections - Check
4
• Radiator Pressure Cap - Inspect for Reuse
770036
Maintenance Procedures at 1000 Hours or 1 Year
• Drive Belt, Cooling Fan - Check
• Cooling Fan Belt Tensioner - Check