wc_tx003611gb_FM10.fm
115
Working with Deep Sea Controller: DSE 7310
10.3 Adjusting Screen Contrast
Overview
The contrast of the LCD display can be adjusted to suit the operator’s preference.
Procedure
Perform the procedure below to adjust the screen contrast.
1. Access the “Editor—Display” menu on the LCD panel (f) by pressing and
holding the check mark button (5) on the keypad.
2. Wait a few seconds for the “Contrast” screen to appear, or use up/down arrow
keys to navigate to the “Contrast” screen. Then, press the check mark button.
The contrast value will start flashing.
3. Press the up/down arrow buttons to change the contrast percentage as desired.
When the screen contrast reaches a comfortable viewing level, press the check
mark button to accept the choice.
4. Exit by pressing and holding the check mark button until the genset controller
returns to the “Status” screen.
Result
The screen contrast has now been changed.
DSE
DEEP SEA ELECTRONICS
wc_gr009802
5
f
DSE 7310
STOP
DEEP SEA ELECTRONICDEEP SEA ELECTRONICSS
DSDSEE
DSE 7310DSE 7310
wc_gr009850
2
3
STOP
To Next Page
Loading...