Watlow ez-zone pm - Page 255

Watlow EZ-ZONE
®
PMI Controller • 251 • Chapter 11 Appendix
Declaration of Conformity
CE DOC EZ-ZONE PM-09-14
Series EZ-ZONE
®
PM
WATLOW Electric Manufacturing Company ISO 9001since 1996.
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following product:
Designation:
Series EZ-ZONE
®
PM (Panel Mount)
Model Numbers: PM (3, 6, 8, 9 or 4)(Any Letter or number) – (1, 2, 3 or 4)(A, C, E, F or
K) (A, C, H, J or K)(Any letter or number) – (Any letter or number)(A, C,
E, F or K)(A, C, H, J or K) (Any three letters or numbers)
Classification: Temperature control, Installation Category II, Pollution degree 2, IP65
Rated Voltage and Frequency:
100 to 240 V~ (ac 50/60 Hz) or 15 to 36 Vdc/ 24 V~ac 50/60 Hz
Rated Power Consumption: 10 VA maximum PM3, PM6 Models.
14 VA maximum PM8, PM9, PM4 Models
Meets the essential requirements of the following European Union Directives by using the relevant
standards show below to indicate compliance.
2004/108/EC Electromagnetic Compatibility Directive
EN 61326
-
1
2013
Electrical equipment for measurement, control and laboratory use
– EMC requirements (Industrial Immunity, Class B Emissions).
EN 61000-4-2 2009 Electrostatic Discharge Immunity
EN 61000-4-3 2010 Radiated Field Immunity 10V/M 80–1000 MHz, 3 V/M 1.4–2.7 GHz
EN 61000-4-4 2012 Electrical Fast-Transient / Burst Immunity
EN 61000-4-5 2006 Surge Immunity (Also compliant with IEC 61000-4-5 2014)
EN 61000-4-6 2014 Conducted Immunity
EN 61000-4-11 2004 Voltage Dips, Short Interruptions and Voltage Variations Immunity
EN 61000-3-2 2009 Harmonic Current Emissions (Also compliant with IEC 61000-3-2 2014)
EN 61000-3-3
1
2013 Voltage Fluctuations and Flicker
SEMI F47 2000 Specification for Semiconductor Sag Immunity Figure R1-1
1
For mechanical relay loads, cycle time may need to be extended up to 160 seconds to meet flicker
requirements depending on load switched and source impedance.
2006/95/EC Low-Voltage Directive
EN 61010
-
1
201
1
2
Safety Requirements of electrical equipment for measurement,
control and laboratory use. Part 1: General requirements
2
Compliance with 3rd Edition requirements with use of external surge suppressor installed on 230 Vac~ power line units.
Recommend minimum 1000 V peak to maximum 2000 V peak, 70 joules or better part be used.
Compliant with 2011/65/EU RoHS2 Directive
Per 2012/19/EU W.E.E.E Directive Please Recycle Properly.
Joe Millanes Winona, Minnesota, USA
Name of Authorized Representative Place of Issue
Director of Operations September 2014
Title of Authorized Representative Date of Issue
Signature of Authorized Representative