EasyManuals Logo

WEG CFW08 Vector inverter Plus User Manual

WEG CFW08 Vector inverter Plus
167 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
71
DETAILED PARAMETER DESCRIPTION
Read-Only Parameters Variables that can be viewed on the
display, but can not be changed by the
user.
Regulation Parameters Programmable values used by the
CFW-08 functions.
Configuration Parameters They define the inverter characteristics,
the functions to be executed, as well as
the input/output functions of the control
board.
Motor Parameters Data about the applied motor: data
indicated on the motor nameplate and
those obtained during the running of the
self-tuning routine.
Special Function Parameters Here are included parameters related to
special functions, like PID regulator.
Figure 6.3 - Block diagram of the local and remote operation mode
LOCAL
Frequency
Reference
P221
Controls
P229 (stop/run,
FWD/REV and
JOG)
0 Keypad
(HMI-CFW08-P and
HMI-CFW08-RS)
1 AI1
2 or 3 AI2
4EP
5 Serial
6 Multispeed
7 Add AI
8 Add AI>0
0 HMI-CFW08-P
keypad
1 Bornes XC1 (DIs)
2 Serial or HMI-
CFW08-RS keypad
REMOTE
Frequency
Reference
P222
Controls
P230 (start/stop,
FWD/REV and
JOG)
0 Keypad
(HMI-CFW08-P and
HMI-CFW08-RS)
1 AI1
2 or 3 AI2
4EP
5 Serial
6 Multispeed
7 Add AI
8 Add AI>0
0 HMI-CFW08-P
keypad
1 Termin. XC1 (DIs)
2 Serial or
HMI-CFW08-RS
keypad
REFERENCE
COMMANDS
Local/Remote Selection (P220)
+
Local/Remote Command
( , DI, serial, etc)
6.3 PARAMETER
LISTING
In order to simplify the explanation, the parameters have been grouped by
characteristics and functions:
F*

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WEG CFW08 Vector inverter Plus and is the answer not in the manual?

WEG CFW08 Vector inverter Plus Specifications

General IconGeneral
Frequency50/60 Hz
Output Frequency0-400 Hz
Overload Capacity150% for 60 seconds
Protection DegreeIP20
Protection FeaturesOvercurrent, Overvoltage, Undervoltage, Short Circuit
BrakingDynamic braking (with optional braking resistor)
Communication InterfaceRS-485 (Modbus RTU)
Ambient Temperature-10°C to +50°C
Humidity5 to 95% non-condensing
Cooling MethodFan Cooled
DimensionsVaries depending on model (refer to specific model datasheet)
Power Range0.75-15 kW
Input Voltage200-240V AC
Storage Temperature-25°C to 65°C (-13°F to 149°F)

Related product manuals