WEG CFW08 Vector inverter Plus - CHAPTER 1 Safety Notices; 1.1 SAFETY NOTICES IN THE MANUAL; 1.2 SAFETY NOTICE ON THE PRODUCT; 1.3 PRELIMINARY RECOMMENDATIONS

CONTENTS
Quick Parameter Reference,
Fault and Status Messages
1 Parameters .................................................................................07
2 Fault Messages ..........................................................................14
3 Other Messages .........................................................................14
CHAPTER 1
Safety Notices
1.1 Safety Notices in the Manual ................................................. 15
1.2 Safety Notice on The Product ................................................15
1.3 Preliminary Recommendations...............................................15
CHAPTER 2
General Information
2.1 About this Manual ..................................................................17
2.2 Version of Software ................................................................ 17
2.3 About the CFW-08 .................................................................18
2.3.1 Differences between the Old µline and the New CFW-08 21
2.4 CFW-08 Identification .............................................................25
2.5 Receiving and Storing ............................................................. 27
CHAPTER 3
Installation
3.1 Mechanical Installation...........................................................28
3.1.1 Environment ..................................................................28
3.1.2 Mounting Specifications ................................................ 29
3.2 Electrical Installation ..............................................................32
3.2.1 Power/Grounding Connections ......................................32
3.2.2 Power Terminals............................................................35
3.2.3 Location of the Power/Grounding/Control Connections ..36
3.2.4 Control Wiring ...............................................................37
3.2.5 Typical Terminal Connections ........................................ 40
3.3 European EMC Directive ........................................................43
3.3.1 Installation .....................................................................43
3.3.2 Inverter Models and Filters .............................................44
3.3.3 EMC Categories Description.......................................... 46
3.3.4 EMC Categories Characteristics Filters .........................47
CHAPTER 4
Start-up
4.1 Pre-Power Checks .................................................................52
4.2 Initial Power-up ......................................................................52
4.3 Start-up ..................................................................................53
4.3.1 Start-up Operation via Keypad (HMI)
Type of Control: Linear V/F (P202=0) .............................53
4.3.2 Start-up Operation via Terminals -
Type of Control: Linear V/F (P202=0) .............................55
4.3.3 Start-up - Operation via Keypad (HMI)
Type of Control: Vector (P202=2) ...................................56