10
QUICK PARAMETER REFERENCES,
ERROR MESSAGES AND STATUS MESSAGES
2. Error Messages
3. Soft-Starter Status
Phase failure or thyristor fault or motor not connected
At the end of time of the programmed acceleration time, the voltage does
not reach 100% UN due to the current limit.
Overtemperature at the thyristors and in the heatsink
Motor overload
Undercurrent (applicable to pumps)
Immediate overcurrent
Phase rotation
External fault
Programming error
Serial communication error
Serial communication error
Display
Meaning
E01
E02
E03
E04
E05
E06
E07
E08
E24
E2X
E29
Soft-Starter is ready to be enabled
Loading pump control parameters
Loading "Default" values
Function enabled
Function disabled
Display
Definition
rdy
PuP
EEP
on
oFF
Second hardware error
1...8
Third hardware error
1...8
Fourth hardware error
1...8
P97
P98
P99
58
58
58
Para- Function Adjustable Factory User's Page
meter Range Setting Setting
To Next Page
Loading...
Need help?
General
