53
5.3 - PARAMETER
CHANGING
b) Flashing Display
Display flashes in the following conditions:
Changing attempt of one non permitted parameter (see
Item 5.3.1)
Soft-Starter in fault condition (see Section: Maintenance)
All information exchange between the Soft-Starter and the
user is made through parameters. The parameter are shown
on the display through the letter "P" followed by a number:
00 = Number of the
parameter
Each parameter is related to a numeric value or a function.
The parameter values define the Soft-Starter programming
or the value of a variable (for instance, current, voltage,
power).
To program the Soft-Starter you must change the parameter(s)
content(s).
USE OF THE HMI
5
To Next Page
Loading...
