41
INSTALLATION
3
Figure 3.12- HMI-3P Cable Connection
The connection of the HMI-3P to the Soft-Starter is made
through shielded flat cable connected to XC6 on the CCS3.0X
control board. The shielding must be connected through a
Faston type terminal near to XC6, as shown in Figure 3.12.
This cable must be laid separately from the other wirings at
a minimum distance of 100mm (3.94in).
OPTIONS:
HMI-3P + 1m (3.28ft) cable
HMI-3P + 2m (6.56ft) cable
HMI-3P + 3m (9.84ft) cable
3.3.1.2 - Electrical
installation
OUTLET THROUGH THE AVALIABLE
SLOT AT THE BOTTOM
FRONT VIEW
To Next Page
Loading...
