WEG SSW-03 Plus Series User Manual

SUMMARY
SUMMARY
1 Parameters .................................................... 07
2 Error Messages.............................................. 10
3 Soft-Starter Status ........................................ 10
1.1 Safety Notices in the Manual ....................... 11
1.2 Safety Notices on the Product ..................... 11
1.3 Preliminary Recommendations .................... 11
2.1 About this Manual ........................................ 13
2.2 Version of Software ....................................... 13
2.3 Abbreviations Used ....................................... 14
2.4 About the SSW-03 Plus ................................. 14
2.4.1 Introduction ....................................... 14
2.4.2 Simplified Block Diagram of the
SSW-03 Plus ....................................... 16
2.4.3 Description of the control
board - CCS 3.0 X ............................... 17
2.5 Product identification ................................... 18
2.6 Receiving ...................................................... 18
3.1 Mechanical Installation ............................... 19
3.1.1 Environment ....................................... 19
3.1.2 Location/Mounting ............................ 20
3.1.3 Kit IP20 .............................................. 22
3.1.4 Connections within the Motor Delta
Connection ......................................... 24
3.2 Electrical Installation ................................... 25
3.2.1 Power/grounding connections ........... 25
3.2.2 Location of the power/grounding/
fans connection ................................. 32
3.2.3 Signal and control connections ........ 32
3.2.3.1 Description of the X2 Connector 33
3.2.4 Fan connections ................................. 34
3.2.5 Combination drive "A" Operation
by HMI, Standard Connection ........... 35
3.2.6 Combination Drive "B" operation
through terminals, Standard Connection 37
3.2.7 Combination Drive "C" operation
through terminals, connection within
the motor delta connection ............... 38
3.3 Installation of Optional Devices .................. 40
3.3.1 HMI-3P on the Panel Door ................. 40
3.3.1.1 Mechanical Installation ........ 40
3.3.1.2 Electrical Installation ............ 41
4.1 Power-up preparation ................................... 42
4.2 Power-up ....................................................... 43
QUICK PARAMETER REFER-
ENCES, ERROR MESSAGES
AND STATUS MESSAGES
1
SAFETY NOTICE
2
INTRODUCTION
3
INSTALLATION
4
POWER UP/
COMMISSIONING

WEG SSW-03 Plus Series Specifications

General

Brand	WEG
Model	SSW-03 Plus Series
Category	Controller
Language	English