WEG SSW-03 Plus Series - Detailed Parameter Description

55
USE OF THE HMI
5
Figure 5.2 - Flowchart for read/changing of parameters
*1 The parameters which can be changed with a running
motor, the Soft-Starter begins to use the new set value
immediately, after pressing key .
The parameter, which can be changed with stopped
motor only, the motor must be disabled, now set the
new parameters and press the key .
NOTE!
If it is not possible to change a parameter with running mo-
tor, the display will indicate the parameter content by flashing.
*2 By pressing the key after the adjustment, the last
adjusted value will be stored automatically and this
value will remain stored untill new changes are made.
*3 The disabling of the parameter changing access is made
by setting P00 at "OFF" or de-energizing/energizing the
Soft-Starter electronics.
READING
CHANGING
YES
NO
SELECT/SET
DESIRED
PARAMETER
PRESS KEY
DISABLE
THEMOTOR
PARAMETER
NEEDS STOPPED
MOTOR FOR
ADJUSTMENT
'?'
SELECT/DISPLAY
DESIRED
PARAMETER
CHANGING/
READ
'?'
SELECT P00
ADJUST P00= ON
PERMITTHEACCESS
TO CHANGE THE
PARAMETERS *3