Operation
7.3 Driving the vehicle
112
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
WARNING
Accident hazard due to blinded motorists!
With work lights switched on, other road users can be blinded. This may
result in accidents that could result in serious injury or death.
► Switch off the work lights when driving on public roads.
► Pay attention to national regulations on construction site lighting.
Before starting to drive, ensure that the vehicle complies with the relevant
local regulations and has a valid type-approval or registration. Only use
attachments on public roads that are approved for this purpose. Follow
the instructions below when driving on public roads.
1) Remove attachments not approved for use on public roads.
2) Secure attachments approved for use on public roads:
– The bucket is emptied and the guard bar is attached to the
bucket.
– The folding pallet fork is folded up and secured.
3) Fully retract the telescopic boom and tilt the power coupler until just
before it stops.
4) If necessary, dismantle protective screen.
5) Check the lighting system and, if necessary, the function of the rotat-
ing beacon.
6) Check and if necessary adjust the rearview mirrors.
7) Move steering column to foremost position.
8) Close driver's door and window.
9) Switch off the work lights.
10) Lock the loader unit.
11) If a trailer is attached, check that the trailer is securely locked in the
trailer coupling, that the lines are correctly connected and that the
loads on the trailer are secured against slipping.
12) Wear your seat belt.
13) Start vehicle travel ensuring safety.
To Next Page
Loading...
