Transportation
8.1 Towing the vehicle
164
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
Bypass aktivieren Bypass deaktivieren
SW4
SW13
1
2
Fig.161: Disable/enable bypass for
towing
Enable bypass A4VG56DA
ü Required tools: Hexagon socket wrench width 4 mm and wrench
wrench width 13 mm
1. Loosen hexagon nuts 2 of the bypass valves.
2. Screw in threaded bolts 1 until they are flush with the hexagon nuts.
3. To tow the vehicle, tilt the cab back and secure it.
4. Close the engine cover.
ð The vehicle can be towed.
Towing
Observe the safety instructions for cooling: see Towing, loading and
transporting on page 30
1. Put the towing vehicle, with sufficient traction force and a safe brak-
ing system, in the towing position.
2. Attach suitable towing equipment (tow bore) to the salvage equip-
ment (eyelets, towing device) on the vehicle.
3. Bear in mind the vehicle’s dimensions and weights.
4. Vehicle at a maximum speed of 5 km/h. For recovery, if possible,
keep the engine running at idle speed.
Disable bypass A4VG56DA
After towing, immediately restore the original setting of the bypass valves.
Otherwise vehicle operation is not possible.
ü Required tools: Hexagon socket wrench width 4 mm and wrench
wrench width 13 mm
1. Unscrew threaded bolts 1 as far as they will go.
2. Tighten hexagon nut 2 to 22Nm torque.
3. Check drive system carefully for function.
ð Vehicle is ready to drive after repair.
To Next Page
Loading...
