Description of the vehicle
5.3 Operating elements at the operator station
44
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
Removing the protective screen
ü Preparations for disassembly completed.
1. Loosen the fastening screws of the protective screen.
2. Remove protective screen.
3. Refasten the screws on the protective screen so that they do not get
lost.
5.2.10.2
Fire extinguisher
Fig.5: Installation site for the fire ex-
tinguisher
The fire extinguisher is not included in the vehicle’s standard equipment.
Only have the fire extinguisher retrofitted by an authorized specialist ser-
vice center. Operate the fire extinguisher according to the instructions
printed on the fire extinguisher.
To maintain the functionality of the fire extinguisher, follow the instruc-
tions below:
• Have fire extinguishers checked regularly or refilled. A corresponding
test badge is located on the container.
• Only use fire extinguishers in an emergency.
• If the fire extinguisher has been used, have it checked immediately by
an authorized service center and refilled. It may be necessary to re-
place it with a new fire extinguisher.
5.3
Operating elements at the operator station
5.3.1
Information on the operating elements
WARNING
Risk of accidents due to damaged control elements and non-func-
tioning warning lights and control lights!
Damaged control elements, control lights and warning lights cannot func-
tion properly. This may result in accidents that could result in serious in-
jury or death.
► Have defective operating elements repaired immediately by an au-
thorized service center.
► Defective warning lights and control lights must be repaired immedi-
ately by an authorized service center.
To Next Page
Loading...
