Maintenance
Lubricating the vehicle and attachment 9.7
195
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
Refilling window wiper water
ü Preparations for maintenance in the engine compartment were car-
ried out.
1. Open the fill opening on the container.
ð Use filling aid, e.g. hose, if necessary.
2. Fill with water, if necessary mixed with window cleaner or anti-
freeze.
3. Close the fill opening.
9.7
Lubricating the vehicle and attachment
9.7.1
Lubricating the vehicle
There are various lubrication points on the vehicle which must be lubric-
ated every 20 operating hours with water-resistant multi-purpose lubric-
ant. The following lubrication plan shows the lubrication points on the
vehicle.
The number of grease nipples is indicated in square brackets under the
lubrication plan. For example: 1 Automatic trailer coupling [1]
This means that there is automatically a grease nipple at position 1 on
the trailer coupling.
Depending on the equipment variant, the number of grease nipples may
vary. If different numbers of grease nipples are possible, the number is
shown as follows: [1]/[2].
The standard version has one grease nipple, the variant has two grease
nipples.
When lubricating, check the bearings of the loader unit and the hydraulic
cylinder. Worn bearing bushings must be replaced by an authorized ser-
vice center.
9
To Next Page
Loading...
