Operation
7.12 Working with attachments
148
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
7.11.5
7-pole plug receptacle at the rear
Fig.141: 7-pole plug receptacle at
the rear
This plug receptacle is used for connecting lights, turn signals and elec-
trical devices on the trailer or attachment. Always install additional lights
on an attachment if the rear lights and other lights are covered by the at-
tachment.
7.12
Working with attachments
7.12.1
Warnings regarding work operation
WARNING
Crushing hazard due to tipping over of vehicle!
There is an increased risk of tipping when driving in curves. This may
cause crushing which may result in serious injury or death.
► Keep the loader unit lowered during vehicle travel.
► Adapt the driving speed to the ambient conditions.
► Adapt the driving speed to the material loaded.
► Pay attention to persons and obstacles.
► Observe tipping limit of the vehicle.
► Reduce speed before downhill travel.
► Always fasten your seat belt.
► Ensure that no parts of the body protrude outside the vehicle.
► Carefully steer the vehicle if the loader unit is raised.
► Do not exceed the permissible payload.
CAUTION
Accident hazard due to overload and sudden movements!
Overload and sudden movements can cause accidents and injury.
► Take into account the vehicle’s payloads.
► Actuate the control lever carefully.
To Next Page
Loading...
