Description of the vehicle
Attachments for the vehicle 5.4
51
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
5.4
Attachments for the vehicle
5.4.1
Information on attachments
NOTICE
Technical damage to the loader unit due to incorrect attachments!
Incorrect attachments can overload the vehicle.
► Only mount attachments to the vehicle that are listed in this oper-
ator’s manual.
► Observe the load diagram to avoid overloads.
Not all attachments are approved for use on public roads. The approved
attachments and the corresponding requirements can be found in the
EBE, the data confirmation or the approval certificate.
Attachments that are not approved for use on public roads must be dis-
mantled and transported to the place of use using a suitable transport
vehicle.
Only attachments listed in the EBE, the data confirmation or the approval
certificate may be attached. Please contact the service partner for other
attachments. An individual operating permit from the competent authorit-
ies is required for the use of other attachments.
The following attachments are described in this operator's manual:
• Standard bucket (lightweight and earth bucket )
• 4-in-1 bucket
• Manure forks
• Fork-and-grab attachment
• Pallet fork
Descriptions of other approved attachments can be found in the oper-
ator’s manuals of the attachments.
The service partner is always available for further questions regarding the
power coupler and the associated attachments.
Bulk densities of materials
The bulk densities given in the table are approximate values. The actual
bulk density may vary.
Material Bulk density t/m³
Building material
Soil, moist 2.10
Soil, dry 1.50
Lime 1.60
Mortar 2.20
Sand, dry 1.65
Sand, moist 2.00
Gravel 2.00
Grain
5
To Next Page
Loading...
