Maintenance
9.15 Cab maintenance
220
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
9.15
Cab maintenance
9.15.1
Checking the seat
▪ Check the correct fastening of the seat, check the fastening screws.
ð The seat must not wobble or be able to be lifted.
▪ Check all seat positions and their locks.
ð When the locks are engaged, the seat may no longer move.
▪ Check seat suspension.
ð Suspension adjustment and suspension must function.
▪ Check seat upholstery.
ð The seat upholstery must not be too worn or damaged.
If damage or defects are found, they must be repaired by an authorized
service center before the vehicle is put into operation.
9.15.2
Checking the seat belt for proper function
WARNING
Risk of injury due to damaged or contaminated seat belt
A damaged or dirty seat belt can cause serious injury or death.
► Keep the seat belt and buckle clean.
► Check the seat belt and buckle for damage.
► Have a damaged seat belt and buckle immediately replaced by an
authorized service center.
► Have the seat belt replaced by an authorized service center after an
accident, even if there is no visible damage. Have the seat fastening
and anchoring points checked for further load-bearing capacity.
▪ Check seat belt for dirt and damage.
ð If necessary, remove dirt.
ð The seat belt must not be damaged.
▪ Check the function of the roll stop.
ð If the seat belt is pulled with a jerking movement, the unrolling must
stop.
▪ Check the retraction function of the seat belt.
ð The seat belt must retract automatically.
Defective belts can no longer fulfill their protective function and must be
replaced.
If damage or defects are found, they must be repaired by an authorized
service center before the vehicle is put into operation.
To Next Page
Loading...
