Commissioning
Commissioning the vehicle 6.5
95
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
6.5
Commissioning the vehicle
6.5.1
Before commissioning
Before commissioning, the following requirements must be met:
• Read and understand the operator’s manual.
• Operate the vehicle only from the operator seat.
• Have technically trained personnel instruct you before using the
vehicle for the first time. Carry out driving tests on spacious terrain.
• Check the condition of the vehicle before starting vehicle travel.
• Have the vehicle checked by technically trained personnel before
commissioning it again after it has been out of operation over a
longer period of time.
• Switch on the battery master switch.
Set up control stand:
1. Adjust the seat.
2. Adjust the steering wheel.
3. Adjust the mirrors.
4. Fasten your seat belt.
5. Turn off all switches and control elements.
6. Apply the parking brake.
7. Deactivate drive interlock if necessary.
ð Start the vehicle.
6.5.2
Information on avoiding engine damage
To avoid engine damage, follow the instructions in this section.
NOTICE
The engine may be damaged!
► Do not put full load on the engine immediately after starting.
► Allow the engine to idle for approx. three minutes. Then slowly in-
crease the speed.
► Do not fully load the engine during the first 100 operating hours.
► Do not use any additional starting aids (e.g. start pilot).
► Contact an authorized service center if the engine does not start.
6
To Next Page
Loading...
